NEW ELECTRIC MOTOR SPEED
CONTROLLERS FOR FOOT THROTTLE, TWIST THROTTLE, THUMB THROTTLE,
HANDLE BAR THROTTLE. REVERSIBLE FOR MOST MOTOR TYPES THAT USE
PERMANENT MAGNETS.
BE SURE TO USE LARGE
GAUGE "00" WIRES ESPECIALLY ON 12 VOLT ENGINE DRIVEN PMG's
PMG's produce
unregulated D.C. voltage and may require a charge
controller for smaller batteries banks or non-grid
connected applications.
"A Real Power House for electric
power generation from wind!" (gearing still recommended for higher
voltages and efficiencies)
To give you engineering types some
idea of how unusually hyper the #PMG226 is, try this test;
Short out the power leads of the
#PMG226 through an amp meter in line and try to turn the
shaft by hand. While under a full load the shaft seems
almost seized BUT during your fatiguing attempt to turn the
shaft you will have produced well over a 35 amp reading on
the amp meter!!!
You say 35 amps just by turning the
shaft by hand? YES! (This test may require vise-grip pliers
for persons with weak grips)
That's 35 amps at well under 1 RPS -
WOW! Not bad for a direct drive unit!
At last, a permanent magnet generator
that does not require a gear box!
Produce power at direct coupled wind
turbine shaft speeds as low as 60 RPM!
Designed to be directly mounted on 8
to 12 foot in diameter high speed wind turbine propellers.